Here are quick instructions for hanging artwork using Vinloom Provided drywall anchors:
-
Mark the Spot: Use a pencil to mark where you want to hang the artwork on the wall. Make sure it is level. Located two locations that fit withing the back lip of the frame.
20x20 Art : 12" approximate spacing
8x8 Art: 3" approximate spacing (or use 1 screw) -
Position the Anchor: Place the drywall anchor tip on the marked spot.
-
Install the Anchor: Using a Phillips screwdriver or a drill, press the anchor into the drywall. Turn it clockwise, applying steady pressure until the anchor is flush with the wall.
-
Insert the Screw: Take the provided screw and insert it into the anchor. Turn it clockwise, leaving a small gap (about 1/4 inch) between the wall and the screw head.
-
Hang the Artwork: Hang the artwork using the wood lip over the screw, ensuring it's securely in place.
-
Adjust as Needed: Step back and check the artwork's alignment. Adjust if necessary.
IF YOU HIT A STUD, forget the ANCHOR. Just use a screw!
- Ensure your hands and fingers are clear of the drilling area to avoid injury. Wear safety goggles to protect your eyes from dust or debris.
- Do not overtighten the screw, as this could cause the anchor to lose its grip or damage the drywall.
- Make sure the artwork is within the weight limits specified for the EZ drywall anchors. Exceeding the limit could cause the anchor to fail.
- If the artwork is heavy or large, ask for assistance to avoid straining yourself or damaging the wall.